PETG Rapido

QIDI PETG Rapido

QIDI PETG Rapido is designed for extreme speed. Its excellent flow and cooling properties allow it to stably support high-speed printing of 300mm/s, while maintaining a strong and efficient balance.

Durable, Waterproof, and Weather-Resistant

QIDI PETG Rapido has good waterproof and weather resistance, can resist the effects of moisture and ultraviolet rays, and is suitable for short-term outdoor use or functional parts.

Balanced Physical Properties

QIDI PETG Rapido retains the inherent strength of regular PETG. It is tougher, more durable, and more resistant to high temperatures than PLA.

Enhanced fluidity and cooling properties

Its improved flowability and cooling stability make it an ideal choice for structural prints that require added strength and stability, with good structural integrity to meet your specific design requirements.

Fast printing, improved efficiency

Print speeds of up to 300mm/s allow you to print faster without compromising quality, allowing you to increase productivity and efficiency.

Equipped with RFID chip

Equipped with RFID chip, parameters are automatically identified, saying goodbye to manual settings.

Accessory Compatibility

	Recommended	Not Recommended
Multi-color printing system	QIDI BOX	/
Support Filament	PLA Basic	/
Build Plate	QIDI PEI Plate, QIDI Smooth Plate, QIDI Cool Plate, HF Plate, PC Plate	/
Nozzle	Brass/Copper plated Nozzle (0.2/0.4 / 0.6/0.8mm) Hardened Steel Nozzle (0.2/0.4 / 0.6mm) Bimetal Nozzle (0.2/0.4 / 0.6/0.8mm) Tungsten Carbide Bimetal Nozzle (0.2/0.4 / 0.6/0.8mm)	/

Recommended Printing Settings
Drying Settings (Blast Drying Oven)	60-65 °C，5-8 h
Nozzle Temperature	240-275 °C
Bed Temperature	70-80 °C
Printing Speed	20-320 mm/s

Physical Properties
Density	1.31 g/cm³
Melt Flow Rate	5~10g/10min
Vicat Softening Temperature	83°C
Heat Deflection Temperature	70℃

Mechanical Properties
Tensile Strength(X-Y)	47 MPa
Tensile Modulus (X-Y)	2000 MPa
Elongation at Break (X-Y)	10 %
Impact Strength (X-Y)	39 KJ/m²

Downloads

Filament TDS

Filament MSDS

Printing Tips

• Pre-printing Drying: PETG is highly hygroscopic.Moist filament may cause stringing and reduced strength during printing.It is recommended to dry at 65°C for 5-8 hours.For extended prints, using a dry box or continuous drying during printing is advised.

📚For more details please refer to: Filament Guide on WIKI.

Vacuum Aluminum Foil Packaging

According to the test, the water vapor transmission rate of ordinary sealed packaging is 4.76%, while the water vapor transmission rate of vacuum aluminum foil packaging we use is only 0.014%. It can be seen that vacuum aluminum foil packaging is more water-resistant.

Product Size

QIDI TECH PETG Rapido Filament 1.75mm Works perfectly with most FDM 3Dprinters on the market.